AS 1892.5 pdf download

AS 1892.5 pdf download

AS 1892.5 pdf download.Portable ladders 1.1  Scope This Standard sets out the minimum requirements and recommended safe practices for the selection, use and maintenance of portable ladders. The requirements of this Standard need not apply where safe work procedures that are equivalent or superior to this Standard are in place. 1.2 Application General recommendations common to the selection, use and...

AS 1289.6.2.2 pdf download

AS 1289.6.2.2 pdf download

AS 1289.6.2.2 pdf download.Methods of testing soils for engineering purposes 4  Principle A predetermined normal stress is applied under one-dimensional conditions, allowing sufficient time for any consolidation or creep to occur and then shearing the soil by displacing one half of a shear box relative to the other. Interpretation of the shearing stage of the test assumes that the soil...

AS 2291 pdf download

AS 2291 pdf download

AS 2291 pdf download.Metallic materials — Tensile testing — Method of test at elevated temperature 3  Terms and definitions For the purposes of this document, the terms and definitions given in ISO 6892-1 apply with the following exceptions and supplements. ISO and IEC maintain terminological databases for use in standardization at the following addresses: — IEC Electropedia: available at http://...

AS 1742.4 pdf download

AS 1742.4 pdf download

AS 1742.4 pdf download.Manual of uniform traffic control devices 1.1  Scope This Standard specifies the traffic control devices to be used for the regulatory control of traffic speed. The Standard does not cover temporary speed limits or the use of advisory speed signs. NOTE  Speed matters excluded from this Standard are covered in the following references: (a) Temporary speed limits...

AS 1289.3.6.3 pdf download

AS 1289.3.6.3 pdf download

AS 1289.3.6.3 pdf download.Methods of testing soils for engineering purposes 1  Scope This Standard sets out a method for the quantitative determination of the particle size distribution in a soil from a coarse sand size down, using an hydrometer for particles finer than the 75 μm sieve (see Clause 9 Note 1). The method as described is applicable if —...

AS 1735.12 pdf download

AS 1735.12 pdf download

AS 1735.12 pdf download.Lifts, escalators and moving walks 1 Scope This European Standard specifies the minimum requirements for the safe and independent access and use of lifts by a wide range of persons, including persons with disabilities. It is applicable to new passenger and goods passenger lifts according to EN 81-20. For other types of lifts, e.g. inclined lifts according...

AS 1735.20 pdf download

AS 1735.20 pdf download

AS 1735.20 pdf download.Lifts, escalators and moving walks 1 Scope This European Standard specifies the safety rules related to new passenger and goods/passenger lifts permanently installed in existing buildings where in some circumstances due to limitations enforced by building constraints, some requirements of EN 81-20:2014 cannot be met. This European Standard addresses a number of these constraints and gives requirements...

AS 2337.3 pdf download

AS 2337.3 pdf download

AS 2337.3 pdf download.Gas cylinder test stations 1  Scope This International Standard specifies the requirements for periodic inspection and testing and to verify the integrity for further service of hoop-wrapped and fully-wrapped composite transportable gas cylinders, with aluminium-alloy, steel or non-metallic liners or of linerless construction (Types 2, 3, 4, and 5), intended for compressed, liquefied or dissolved gases under...

AS 2150 pdf download

AS 2150 pdf download

AS 2150 pdf download.Asphalt — A guide to good practice 3  Terms and definitions For the purpose of this Standard, the following terms and definitions apply. 3.1 added filler mineral matter, suitable for use in asphalt that is added to the combined aggregate of an asphalt mix Note 1 to entry: At least 75% of the filler should be finer...

AS 1484.13.1 pdf download

AS 1484.13.1 pdf download

AS 1484.13.1 pdf download.IEEE Standard for Learning Technology— Conceptual Model for Resource Aggregation for Learning, Education, and Training 3. Definitions, acronyms, and abbreviations 3.1 Definitions For the purposes of this document, the following terms and definitions apply. The IEEE Standards Dictionary Online should be consulted for terms not defined in this clause. 3 aggregation definition document: A document that lists...